Auto Mode - Seeley BreezeAir ILL239-D Owner's Manual

AUTO MODE

The remote control contains a
thermostat. In AUTO mode the cooler
is controlled automatically, based on
your pre- selected
cooler will adjust the fan speed,
switch between COOL and VENT and
turn itself off. However, the sequence
and regularity at which these settings
change will differ with each operation
of the cooler.
As the remote control senses room
conditions, the comfort control
settings will be influenced by
from direct sunlight or electrical
appliances. Likewise placing the
remote control in cupboards or
drawers or under cooling vents will
affect the cooler's operation.
To set the AUTO mode press the
button until AUTO is displayed.
AUTO
FAN
SPEED
Ten levels of comfort are available
with the remote control. While in
AUTO mode pressing the
buttons will adjust the level of
required comfort. The display
show your selection by indicating a
level between 1 and 10. WARMER or
COOLER will be displayed on the
screen as settings are changed.
®
6
comfort level. The
heat
PM
ILL1105-A
and
will
Evaporative Cooler
AUTO TIMER MODE
AUTO TIMER mode can be
selected by using the
Once the AUTO TIMER mode is
selected the cooler will only
operate during the programmed
time period.
Programming the timer must be
performed before AUTO TIMER
can be activated. This can be done
while in any mode, even when it is
OFF. There are 7 steps involved in
setting the AUTO TIMER.
NOTE: After pressing the
button the display will revert back
to the previous setting if no buttons
are pressed within 4 seconds.
To program the timer use the
following sequence:
(1) Setting the ON time hour
Begin by pressing the
button. The hour displayed will
start flashing and the word ON will
appear on the screen. Then use
the and
change the hour value.
AUTO
TIMER
button.
buttons to
ON
ILL1112-A