Seeley BreezeAir ILL239-D Owner's Manual page 10

BATTERIES
If the batteries are installed when the
display is completely blank, the
display will remain blank for 5
seconds. After 5 seconds the display
will show "Id" for 1 second, then
display the clock. The remote control
is now ready to use.
The remote control requires 3 AAA
batteries. The use of good quality
alkaline batteries is recommended.
Under normal conditions a set of
batteries will operate for 18 months.
Do not use rechargeable batteries as
their voltage rating is too low for the
remote control.
When the batteries are getting low on
power, BATTERY LOW is displayed
on the screen (the cooler may also
switch off while the display remains
ON). This indicates that the batteries
have only a small amount of life
remaining.
AUTO
FAN
SPEED
To change the batteries remove the
cover from the back of the remote
control. Pull out the old batteries and
replace them all with the new ones.
Do not mix new batteries with old
batteries.
The remote control has 2 minutes of
back-up power to retain its memory
while the batteries are being changed.
®
10
COOL
PM
BATTERY LOW
ILL1106-A
Evaporative Cooler
DIP SWITCHES
There are 2 rows of DIP switches
located under the battery cover on
the remote control.
WARNING: Do not alter DIP
switches 1 to 10 as the cooler
will cease to work.
1 2 3 4 5 6 7 8
ON
OFF
A B C D E F 9 10
ON
OFF
EXAMPLE ONLY
Definition of DIP switch positions
(first 6 in bottom row only) are as
follows:
(A). Reserved for later use.
(B). OFF, 24 hour clock.
ON, 12 hour clock.
(C). OFF, 1100 / 1500W motor.
ON, 380 / 550 / 750W motor.
(D). OFF, no pre-cool.
ON, pre-cool.
(E). OFF, drains 3 days after
power off.
ON, drains 3 hours after
power off.
(F). OFF, drains every 65 minutes
of operation.
ON, activates water salinity
circuit (WaterManager ).
ILL217-G
®