Seeley BreezeAir ILL239-D Owner's Manual page 17

PRE-SEASON
(1)...Turn your main switchboard
power off.
(2)...Remove the pad frames as
shown in the next column.
(3)...Ensure the power is off at
the isolating switch inside the
cooler.
(4)...Gently wash the pad frames
to remove any dust build up
during the winter.
not wash the pads with
high pressure water spray.
If the pads are salted-up
replace them.
(5)...Replace the bleed system
that was removed at the end
of the last season. Ensure
that the o-ring is in place and
that the tray is positioned so
that it can catch the water
from the pad.
(6)...Turn on the water supply to
the cooler.
(7)...Check for water leaks.
Check operation of float
valve.
(8)...Check if adj. required to belt
drive. Reset motor amps.
(9)...Switch on the isolating
switch.
(10).Refit the pad frames.
(11).Turn the power on at your
main switchboard.
(12).Run the cooler.
Do not run the cooler with
the pad frames removed.
REMOVING PAD FRAMES
To remove a pad frame:
(1)...Remove the clips holding the
pad frame in place.
(2)...Insert a flat head screw
driver into the slot between
the lid and the top of the pad
frame. Lever it so the pad
frame is released.
NOTE: Do
(3)...... Take hold of the pad frame,
pivot it outwards and lift it up. Be
careful not to damage the pad.
Repeat the steps above with the 3
remaining pad frames.
(For EXH210 units only) There are
90mm pads fitted to the front and rear,
with 100mm pads fitted to the sides
(facing the fan scroll holes). These
pads must be re fitted to their original
positions, or the larger pads could
catch on the float valve or components
mounted on the scroll.
If fitted incorrectly, a drop in
performance may be found, water
can bypass the pad and be carried
over into the airstream and ducting
and/or damage to the pads or
electronic components may occur.
WARNING:
The 100mm pads can be identified by
a rebate at the base of the Chillcel.
SEELEY INTERNATIONAL – OWNER'S MANUAL
3
3
2
1
ILL950-C
1
2
ILL187-E
17