Options - Valor Retrofire RF24IDN Installation And Owner's Manual

Low Battery Indication
Remote handset: BATT will appear on the display when
the battery needs to be replaced.
Replace with one 9 V alkaline battery.
Receiver: Three short 'beeps' will sound when the motor
turns when the batteries need to be replaced. Replace with four 1.5 V alkaline batteries.
NOTE: With very low battery, the valve shuts off the fi re completely. This does not happen when the power supply is
interrupted.
Handset / Receiver Match
The remote control handset and receiver are programmed to function together. In case of a replacement of the handset
or the receiver, you will need to reset the receiver to allow them to function together. Contact your dealer for details
Automatic Standby Mode
If there is no transmission from the handset to the receiver within a 6-hour period, the appliance will go to Standby
(pilot) mode.
Appliance
RF24IDN—Natural Gas Installations
RF24IDP—Propane Gas Installations
Decorative Cast Iron Frets
RA24CV—Contemporary, Vintage Iron Finish
RA24AV—Avant-Garde. Vintage Iron Finish
RA24TB—Traditional, Black Finish
1225VFB—Ventana Fret, Black
Venting
Pipe—generic 3" diameter fl exible aluminum liner
approved for gas venting—see list below.
Termination—Miles Industries' 559CLT Co-Linear
Termination and 559SFK Square Flashing Kit are
recommended for terminating existing masonry
chimney applications—see list below for other
approved venting accessories.
24
Remote Control Operation
DO NOT USE a screwdriver or other metallic object
to remove the batteries from the battery box or the
handset! This could cause a short circuit.

Options

Optional Kits
555CFK—Circulating Fan Kit with 6'–0" c/w grounded
cord set.
1265WSK—Wall Switch Kit
Conversion Kits
RA24NK—to convert from LPG to Natural Gas
RA24PK—to convert from Natural Gas to LPG
Hearth Gate (optional)
Hearth gates such as Kidco's are available at retail
stores carrying safety products for children.
CAUTION