Toshiba e-Studio 232 Operator's Manual page 28

1.Description of Each Component (Cont.)
8. Slot Cover
1
This cover is used when the 2nd Drawer is not installed.
9. Saddle Stitch Finisher (MJ-1025)
This finisher enables saddle stitching, in addition to sort/group finishing and stapling. (The Hole Punch
Unit sold separately can be installed to this finisher.) The Bridge Unit (KN-3520 sold separately) is
required when installing this finisher.
10. Hanging Finisher (MJ-1022)
This finisher enables sort/group finishing and stapling. The Bridge Unit (KN-3520 sold separately) is
required when installing this finisher.
11. Hole Punch Unit (MJ-6005)
This unit enables you to punch holes on printouts. It can be installed to the Saddle Stitch Finisher (MJ-
1025).
12. Automatic Duplexer
Enables duplex copying.
The Automatic Duplexer may be optional.
Other options available are as follows. Contact your service technician or Toshiba product distributors for
details. (Options may vary depending on destination.)
Work Table (KK-3511)
This is a small table for placing originals while the equipment is operated.
• Cannot be installed with e-BRIDGE ID Gate at the same time.
FAX Unit (GD-1150)
This is a unit for using the equipment as a Fax.
• Installed inside of the equipment
2nd Line for Fax Unit (GD-1160)
This unit enables to add a line to the Fax to make it 2nd line.
• Installed inside of the equipment
• The Fax Unit (GD-1150) is necessary.
Desk (MH-1700)
This is a desk for the equipment.
Data Overwrite Kit (GP-1060)
This is a kit to erase the data stored temporarily when copying, printing, scanning, Fax, internet Fax or net-
work Fax is performed. It overwrites temporarily stored data with random data.
• Installed inside of the equipment
Scrambler Board (GP-1040)
This board enhances the security of the equipment. Data are encrypted when they are written into the hard
disk of the equipment, and decrypted when they are read.
• Installed inside of the equipment
• The PCI Slot (GO-1060) is necessary.
Wireless LAN Module (GN-1041)
This module enables the equipment to be used in a wireless LAN environment.
• Installed inside of the equipment
• The Antenna (GN-3010) is necessary.
• The equipment cannot be connected to the wireless and wired LAN at the same time.
26
1.BEFORE USING EQUIPMENT