Chapter 2: Board Installation - TYAN S7053 User Manual

Chapter 2: Board Installation

You are now ready to install your motherboard.
How to install our products right... the first time
The first thing you should do is reading this user's manual. It contains important
information that will make configuration and setup much easier. Here are some
precautions you should take when installing your motherboard:
(1) Ground yourself properly before removing your motherboard from the
antistatic bag. Unplug the power from your computer power supply and then
touch a safely grounded object to release static charge (i.e. power supply
case). For the safest conditions, TYAN
wrist strap.
(2) Hold the motherboard by its edges and do not touch the bottom of the board,
or flex the board in any way.
(3) Avoid touching the motherboard components, IC chips, connectors, memory
modules, and leads.
(4) Place the motherboard on a grounded antistatic surface or on the antistatic
bag that the board was shipped in.
(5) Inspect the board for damage.
The following pages include details on how to install your motherboard into your
chassis, as well as installing the processor, memory, disk drives and cables.
Caution!
1. To avoid damaging the motherboard and associated
components, do not use torque force greater than
7kgf/cm (6.09 lb/in)
motherboard installation.
2. Do not apply power to the board if it has been
damaged.
http://www.TYAN.com
®
recommends wearing a static safety
on each mounting screw for
15