Connections And Driver Installation (Macintosh); Making Connections And Installing The Driver - Edirol UA-3 Getting Started Manual

Connections and driver installation (Macintosh)

* If you are a Windows user, refer to p. 10.
In order to use the UA-3, you must first install a driver. UA-3 uses a driver
included with Mac OS.

Making connections and installing the driver

Making connections
(943)
Always make sure to have the volume level turned down before connecting
the UA-3. Even with the volume all the way down, you may still hear some
sound when the power is switched on, but this is normal, and does not
indicate a malfunction.
(921)
To prevent malfunction and/or damage to speakers or other devices, always
turn down the volume, and turn off the power of all devices before making
any connections. (It is not necessary to turn off the power of your computer.)
Use a USB cable to connect the UA-3 to your computer before turning on the
power of your audio equipment.
fig.03-01.e
Stereo Set
Powered Speaker etc.
LINE IN, AUX IN
24
Computer
Audio
USB cable
cable
USB
LINE OUT
port
UA-3
What is a driver?
-> p. 10
USB
port
Before disconnecting
the USB cable or
restarting Macintosh,
*Connect after starting
please close all
up the computer.
applications. You
should also turn down
the volume of any
audio or amp system
that is connected.
This unit is equipped
with a protection
circuit. A brief interval
Stereo
Headphones
(a few seconds) after
connecting a USB
connector is required
before the unit will
operate normally.