Driver Installation And Settings (Mac Os 9) - Edirol UA-4FX Advanced Operation Manual

Driver installation and settings (Mac OS 9)

Installing the UA-4FX driver
Use either OMS or FreeMIDI as the MIDI driver.
The included UA-4FX driver is an add-on module for using the UA-4FX with OMS
or FreeMIDI.
OMS can be found in the OMS 2.3.8 E folder within the OMS (Mac OS 9) folder of
the CD-ROM. If you would like to know more about OMS, refer to
OMS_2.3_Mac.pdf which can be found in the same folder.
* Either OMS or FreeMIDI must be installed in your Macintosh, as appropriate for the
sequencer software you are using.
* If you install OMS or FreeMIDI after installing the UA-4FX driver, you must install the
UA-4FX driver once again.
If a UA-4FX is already connected to your Macintosh when you install the driver, a
message like the following will appear when the Macintosh is started up. Perform the
steps described below as appropriate for the message that is displayed.
If the screen indicates:
"Software needed for the USB device "UA-4FX" is not available. Would you
like to look for the software on the Internet?"
→ click [Cancel].
Use the following procedure to install the UA-4FX driver.
1. With the UA-4FX disconnected, start up Macintosh.
* Disconnect all USB cables except for a USB keyboard and USB mouse (if used).
2. Exit all currently running software (applications).
3. Prepare the CD-ROM.Insert the CD-ROM into the CD-ROM drive.
4. Double-click the UA-4FX Driver-E Installer icon (found in the Driver E (Mac OS 9)
folder of the CD-ROM) to start up the installer.
5. Verify the Install Location, and click [Install].
The installation location will be shown differently depending on your system. Make
sure that you have selected the startup disk for the system you are currently using.
6. If a message like the following is displayed,
click [Continue].
The other currently running applications will
exit, and installation will continue.
39