Mounting Grille Facia Panel - AGA marvel M60CSS Installation, Operation And Maintenance Instructions

Mounting grille facia panel:

Depending on your model cut the facia panel to the size
shown in Figure 23 or Figure 24. Drill the two facia bracket
screw pilot holes in the back side of the facia panel as
noted in Figure 23 or 24. See Table B, for sizes. Fasten
the two or three facia brackets to the back side of the facia
panel with 2 or 3 of the screws provided. See Figure 25.
Align the facia brackets so they are parallel to the short
edges of the facia panel and drill the remaining 2 or 3
bracket holes using the holes in the facia brackets as
guides. Secure the bottom of the brackets with the 2 or 3
remaining screws.
The facia panel may now be mounted to the grille back.
CAUTION
!
When cutting the facia panel for the grille do not make it
larger than the size noted in Figure 23 or 24. Air flow to the
condenser in the power module would be compromised.
Grille facia panels must not exceed 20 pounds (9.1kg),
panels weighing more could cause product damage. Do
NOT use glass, mirrors, granite or similar heavy materials
for panels.
Facia Diagram for 60" Wide Models:
(144.8cm)
7 ⁄ "
13
32
(18.8cm)
Drill 2 holes, see Table B.
CUSTOM GRILLE FACIA AND DOOR PANELS
57"
(2.9cm)
42 ⁄ "
3
16
(107.2cm)
Figure 23
Facia Diagram for 72" Wide Models:
7 ⁄ "
3
8
(18.7cm)
1 ⁄ "
1
8
(2.9cm)
Facia panel-
Screw 2 or
3 required-
1 ⁄ "
1
8
Drill bottom 2 or 3
holes for mounting
brackets and secure
8 ⁄ "
3
4
with remaining 2 or 3
(22.2cm)
24
69"
(175.3cm)
27 ⁄ " 27 ⁄
3 3
32 32
(68.8cm) (68.8cm)
Figure 24
Drill 3 holes, see Table B.
MATERIAL HOLE SIZE
Hardwood 1/8" (3.2mm)
Softwood 7/64" (2.8mm)
Table B
-Facia bracket
screws.-
Figure 25
"
8 ⁄ "
3
4
(22.2cm)