Overlay Drawer Panel Installation - AGA marvel ML24RD Installation, Operation And Maintenance Instructions

Refrigerated drawers

Hide thumbs Also See for ML24RD:

Installation, operation and maintenance instructions (20 pages)

Table Of Contents

Table of Contents

CAUTION

It is important to use the factory provided grille that came

with the product to assure proper air flow is maintained

through the condenser. The use of a custom grille is not

recommended and will void the warranty.

Full Overlay Panel Installation Instructions

Determine Wood Screw Requirements

1. A #10 pan head wood screw should be used to proper-

ly secure the overlay panel (See Figure 13). A quantity

of 16 screws are supplied with the unit in the literature

pack.

2. Use only pan head screws.

3. If your overlay panel is thinner than

you will need to purchase shorter screws. The longer

screws will break through the front of the panel.

Step 1: Remove Drawers from unit.

1. Begin by pulling out the top drawer. (See Figure 10).

Remove screws securing drawer to slides (See Figure

11). Pull drawer forward, lift up and out to clear clips in

rear of drawer. Move drawer forward about 1" (2.5 cm)

and set down on slides. At the right rear corner of the

drawer disconnect the display wire harness (See Figure

10a). Remove the drawer from the unit by lifting up off

of the slides. Repeat for bottom drawer but disregard

the harness instructions as there is no wiring to the bot-

tom drawer.

2. Remove the gasket from the drawer front. (See Figure

11). Do this by pulling the gasket out of the channel that

holds it to the drawer front. This will expose the clear-

ance holes for mounting the overlay panel. (See Figure

15).