Full Overlay Panel Installation Instructions - AGA marvel 30iMT Installation, Operation And Maintenance Instructions

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS

Step 1: Verify door alignment
Verify that the door is aligned correctly with the cabi-
net prior to fabricating the custom panel. Failure to do
so may result in mis-alignment of the custom panel
with the hinge bracket. The door should be parallel to
the sides and top of the ice machine. If alignment is
necessary the door may be adjusted by loosening the
2 screws which secure the top and/or bottom hinge
adapter brackets, located on the top and bottom of the
door and adjusting the door side to side. Use a
wrench, for this procedure. (See Figure 9 below). When
fi nished aligning the door, tighten the screws securely.
Hinge adapter bracket
located on the top and bot-
tom of the door.
Figure 9
Step 2: Remove door
Remove the top hinge pin from the hinge with an
wrench. Remove the door by angling the top of the door
outward and lifting the door off the bottom hinge.
(See detail in Figure 9).
Step 3: Remove gasket
Lay the door on its front being careful not to scratch it. To
gain access to the screw mounting holes remove the door
gasket by peeling up and out of the channel.
Step 4: Cut overlay panel
Depending on the ice machine model cut the overlay panel
to the dimensions shown in Figure 10 and Table B.
⁄ " allen
5
32
Remove top hinge
pin to remove the
door.
⁄ "
9
32
(7mm)
Door should be
parallel to top
and sides of
ice machine.
⁄
1
(19mm) maximum to
mum space of
fl ange as shown . This space can be adjusted by adjusting
the top and bottom hinge adapters.
Step 5: Drill hinge clearance holes in overlay
" allen
panel
8
Set the overlay panel on the door front, align the edges,
and clamp together. Clamp the panel fi rmly but be careful
not to damage the door or the panel. Mark center of hinge
adapter hole on wood panel, top and bottom. (See Figure
11.) Remove wood panel from door and drill
ameter clearance holes into the overlay panels
deep. These will be clearance holes for the top and bottom
hinge pins.
This is also a convenient time to locate and drill the holes
for your handle. Most often the handle is to match that of
14
For overlay with lock option
NOTE
panel thickness to be
⁄ " (16mm) minimum.
5
8
Weight of the overlay panel
should not exceed 20 pounds
(9.1 kilograms).
For the door to work properly it
NOTE
is necessary to maintain a mini-
⁄ " (7mm) between the door and cabinet
9
32
W
Front of
overlay
panel
Figure 10
Model W
14 ⁄ "
5
30iMT
8
(37.1cm) (77.0cm)
14 ⁄ "
5
30iMAT 8
(37.1cm) (70.3cm)
Table B
⁄ "
3
4
H
H
30 ⁄ "
5
16
27 ⁄ "
11
16
⁄ " (8mm) di-
5
16
⁄ " (20mm)
3
4