Installing Two Units Side By Side - AGA marvel M60CSS Installation, Operation And Maintenance Instructions

Installing Two Units Side-By-Side
When two (2) units are installed together, a divider panel
needs to be installed between the two (2) power modules
(refer to Figure 14). The divider panel is fastened to the
freezer right side at the top of the cabinet. Remove the two
screws holding the divider panel in place, flip over so the di-
vider is above the cabinet and secure with the two removed
screws.
NOTE
If the divider panel is not installed, the warm discharge air
from the refrigerator module will be drawn into the intake of
the freezer module causing the freezer module to not oper-
ate properly.
Mount the junction box next to the right hand module with
the double face tape provided to the cabinet top. Plug the 2
power cords from the modules into this junction box and the
junction box power cord into the power supply.
Divider
panel
Figure 14
Securing the trim:
Install a wood shim (provided) cut to the dimensions shown
in Section A-A to the side trim of the first cabinet to be
installed in the rough in opening. After installing the second
cabinet drill and install screws into the wood shim for the
second cabinet.
INSTALLING THE TWO UNITS SIDE BY SIDE
Junction box with
power cord
A
A
Drill three (3) holes
each side equal
distance apart in
vertical section of
aluminum frame
and install screws
as shown.
Section A-A
U-shaped
mullion cover
Mounting U-shaped mullion cover:
Remove paper backing from tape on inside of mullion cover
(3) places. Press U shaped mullion cover over cabinet trim
at center of cabinet as shown.
18
Wood Shim
⁄ " x ⁄ " x 68"
7 7
8 8
(22.4mm x 22.4mm
x 165.1cm)
⁄ "
7
8
(22.4mm)
⁄ "
7
8
(22.4mm)
-Cabinet trim-
Tape, (3) places
along length of
cover