Mounting Grille Facia Panel - AGA marvel M24TF Operation Manual

Mounting grille facia panel:

Cut the facia panel to the size shown in Figure 21 and
Table B. Drill the two facia bracket screw pilot holes in the
back side of the facia panel as noted in Figure 21. See
Table C, for sizes. Fasten the two facia brackets to the back
side of the facia panel with 2 of the screws provided. See
Figure 22.
Align the facia brackets so they are parallel to the short
edges of the facia panel and drill the remaining 2 bracket
holes using the holes in the facia brackets as guides.
Secure the bottom of the brackets with the 2 remaining
screws.
The facia panel may now be mounted to the grille back.
CAUTION
!
When cutting the facia panel for the grille do not make
it larger than the size noted in Figure 21. Air flow to the con-
denser in the power module would be compromised. Grille
facia panels must not exceed 20 pounds (9.1kg), panels
weighing more could cause product damage. Do NOT use
glass, mirrors, granite or similar heavy materials for panels.
"B"
1 ⁄ "
1
8
(2.9cm)
Drill 2 holes, see Table C.
MODEL "A"
M24TF-WP 21" (53.3cm)
M30TF-WP 27" (68.6cm)
M36TF-WP 33" (83.8cm)
CUSTOM GRILLE FACIA AND DOOR PANELS
"A"
"C"
Figure 21
"B" "C"
2 ⁄ " (6.8cm) 15 ⁄ " (39.8cm)
21 11
32 16
2 ⁄ " (6.8cm) 21 ⁄ " (55.1cm)
21 11
32 16
7 ⁄ " (18.7cm) 18 ⁄ " (46.4cm)
3 1
8 4
Table B
Facia panel-
Screw 2
required-
Drill bottom 2 holes
for mounting brack-
ets and secure with
remaining 2 screws.-
8 ⁄ "
3
4
(22.2cm)
Custom Door Panel Installation Instructions
Determine Wood Screw Requirements
1. A #10 pan head wood screw should be used to prop-
erly secure the overlay panel (See Figure 28). Screws
are supplied with unit.
2. Use only pan head screws.
3. If your overlay panel is thinner than
you will need to purchase shorter screws. The longer
screws will break through the front of the panel.
17
MATERIAL HOLE SIZE
Hardwood 1/8" (3.2mm)
Softwood 7/64" (2.8mm)
Table C
-Facia bracket
Figure 22
⁄ " (15.9 mm)
5
8