Gas Conversion Range And Rangetop - GE Monogram ZDP486ND Technical Service Manual

Attach the Anti-Tip Brace onto the bottom of the
range in the recessed area. Install 2 hex screws
(provided) through the brace and into the range.
Note: This Anti-Tip device may be installed on the
opposite side of the range.
Alternate Brace
Position
1. Measure and mark Dimension A (see table
below) from the left (or right) side of the
installation location. If the countertop has an
overhang, add that dimension to Dimension A.
2. Place the Anti-Tip Bracket against the fl oor and
back wall at the marked location. Mark screw
holes for fastening the bracket to the wall sole
plate and the fl oor.
3. Drill 1/8" pilot holes at a 20° angle.
4. Secure the bracket to the wall and/or fl oor with
at least 2 wood screws (provided).
For Concrete or Cement Construction: You must
use appropriate fastening hardware (not provided).
Anti-Tip Bracket
A
Range
30"
36"
48"
Hex Screws
Anti-Tip Brace
Wall Sole Plate
A
5-1/16"
5-1/16"
8-1/4"
– 22 –

Gas Conversion Range and Rangetop

WARNING:
This conversion must
be performed by a qualified installer or gas supplier
in accordance with the manufacturer's instructions
and all codes and requirements of the authority having
jurisdiction. Failure to follow instructions could result
in serious injury or property damage. The qualified
agency performing this work assumes responsibility
for the conversion.
WARNING:
The rangetop, as shipped from
the factory, is set for use with its intended gas. If you
wish to use your rangetop with the alternate gas, you
must first replace the orifices and convert the pressure
regulator.
WARNING:
The following adjustments must
be made before turning on the burner. Failure to do so
could result in serious injury. Be sure pressure regulator
has been converted as described in Step 2.
TOOLS YOU NEEDED FOR CONVERSION
Crescent Wrench
Safety Glasses
1/2" Deepwell
Small Pliers
Socket Wrench
1
ORIFICE HOLDER
The range orifice holder
is located behind the front
access panel at the bottom
of the range.
The rangetop orifice holder
is located inside the range insulation cover.
Additional orifices may be present. Use only the orifices
specified in the instructions for your range or rangetop.
1/4" and 7mm Nutdrivers
Small Flat-Head Screwdriver
(2 to 2.4 mm or 3/32" tip size,
60 mm long)
Philips
Screwdriver
Griddle Grill
Orifice Orifice
Burner Orifices