Grill Burner Igniter; Grill Safety Valve - GE Monogram ZDP486ND Technical Service Manual

Grill Burner Igniter

Note: The following describes the procedure to
remove the grill burner igniter. The grill igniter
has a resistance value of 45 to 400 Ω at room
temperature.
To remove the grill burner igniter:
1. Remove the grill burner. (See
Note: In the following step, ensure that the spring
clip is captured and retained inside the grill burner
box.
2. Squeeze the ends of the spring clip and retract
the clip from the harness access cutout on the
left side of the grill burner box.
Spring Clip
3. Pull the harness connector thru the cutout and
disconnect the igniter wire harness.
Note: The following describes the procedure to
remove the grill safety valve. The grill safety valve
has a resistance value of 1 Ω or less.
To remove the grill safety valve:
1.
.)
Grill Assembly
2.
3. Disconnect the wires from the valve.
4. Remove the heat barrier.
5. Remove the 9/16-in. nut from the valve.
6. Remove the 1/4-in. hex-head screw that
– 33 –

Grill Safety Valve

Remove the grill assembly. (See
Remove the two 1/4-in. hex-head screws that
attach the heat shield.
Heat Shield
Heat Barrier
attaches the valve to the valve bracket and
separate the valve from the gas tube and valve
bracket.
.)
Grill Assembly
Disconnect
Disconnect