Gas Conversion - GE ZGP484NG Installation Instructions Manual

Installation Instructions for Gas Conversion
ii,,,lul i i i
[_ CHANGE BURNER ORIFICES (cont.)
IMPORTANT: Findyour model number below. Read
each orifice label to identify and instalJthem in the
exact locations shown.
ZGP304 SIMMER ORIFICES
A 34SL or 51SN 6rifice
wilt be used on all burners.
ZGP304 MAIN ORIFICES
oArStc%Lw°ir, j _2e6 mXN _1_ L _
used on these
three burners.
r ,,.Lp.... Nat 7
108XL j 190XN I 1
Use a 108×L or
190×N orifice for
the right front
burner.
ZGP364, ZGP366, ZGP484, ZGP486
SIMMER
ORIFICES
MAIN
ORIFICES
or e
will be used on oli
burners.
I__l Use 108XL or
190XN orifices for
oil burners.
A. Return the unused orifices to the holder. Reattach
the holder and the instruction sheet with screw
in the original storage location.
B. Replace the burner heads, caps and top grates.
On range models,replace rear vent trim.
1_ CHANGE GRILL ORIFICE (if present)
Locatethe 1-1./2"long Grillorifice.
Select t he properorificesizefor your gas and
burnerfrom the conversionchart
A. Removethe grill cover,grates and grate
frame. Liftthe radiant baffle straight up and off.
B,
C,
Removethe 2 hex
head screws from the l_
Remove
top of the igniter. 2 hex
• Removeone screw head
from each side of the screws
burner surround.
• Lift out the surround.
illllllll llllllllllllllllllll IIIIIIIII
Carefullypushthe igniter asideand under the burner.
Do not pull or pinch the wire.
Remove4 burner attachment screws.2 at the front and
2 at the back.Slidethe burner assemblytoward the
back and out of the gas inlet.
Burner niter
Surround
Jrner
,'Assembly
23
D,
Usea i/2" d eepwell
socket to remove and
replacethe orifice.
Reverse these steps }']_
to re-assemblethe
grill. Besureto place
the unusedorifice in
the holderfor possible
future use.
Front of Range
.HHr I,U