Vocal Harmonist Function; Setting Up - Roland G-70 Owner's Manual

G-70 Music Workstation
Quick Start
The [USER] field lights to indicate that your settings
are now being used.
(5) Press the [EXIT] button to return to the main page.
Your last preset selection (MELODY~USER) will be
used until you select another preset or until you
switch off your G-70.
(6) Press [MINUS≈ONE] again to switch off this func-
tion.
Note: You can also switch the Minus One function on/off
using an optional footswitch (page 68).
42

Vocal Harmonist function

The Vocal Harmonist is another highlight of your G-70.
In fact, it doesn't just produce harmonies: it can also
transform your voice in various ways. More impor-
tantly, its sound quality surpasses by far anything you
may already have tried.

Setting up

Here's what you need to do to take advantage of the
Vocal Harmonist function:
(1) Connect a dynamic microphone to the INPUT jack
on the G-70's rear panel.
Set to "MIC"
Examples: Roland DR-10 or DR-20
(2) Set the [INPUT] switch to "MIC".
You can also connect the (mono) output of other
instruments. In that case, you need to set the switch
to "LINE".
Set to "LINE"
L/MONO
VOLUME COMBINATION PALETTE
1 2
1>Piano 1
Preset:001
Synthesizer, sound module, etc.
(3) Set the [INPUT≈GAIN] knob on the front panel to
"MIN".
Note: If you like, you can connect the Vocal Harmonist OUT-
PUT sockets to another amp (or additional mixer channels).
(4) Press the [SINGER] button (it must light) and switch
off the [VOCODER], [SMALL] or [ENSEMBLE] button.
(5) Sing into the microphone and gradually increase
the [INPUT¥GAIN] setting.
SPLIT DUAL X-DUAL ON/OFF PALETTE TRANSPOSE EDIT UTILITY SEQ CTRL
SELECT /
KEYBOARD MODE ARPEGGIO EXIT CANCEL
PART PERFORM 1 2 3 4 5 TONE
/ TONE VARIATION
LOWER UPPER VIBRATO FILTER ENVELOPE DRUM TONE
VALUE USER 6 7 8 9 0
/ PRESET ENTER EDIT
ROM PLAY LEVEL/PAN MIDI/TUNE KEYBOARD CONTROL ARPEGGIO PERFORM
/EFFECT /SYSTEM
INPUT GAIN
OVER
MIN MAX
SINGER