Switching The G-70 On/Off; Internal Memory Protect; Setting The Display Contrast; Switching Off The G-70 - Roland G-70 Owner's Manual

Hide thumbs Also See for G-70:
Table of Contents

Advertisement

Switching the G-70 on/off

After connecting the G-70 to the other devices, proceed as follows:

Internal Memory Protect

After unpacking your G-70 –and before switching it on– you
need to defeat the protection of its internal memory (a solid-
state hard disk) if you intend to save data in the internal
memory.
• Use a philips screwdriver to loosen the screws and remove
the plastic cap.
• Slide the INTERNAL MEMORY PROTECT switch to the " "
position to unlock the memory.
(To once again lock the internal memory, slide the switch
back to the " " position.)
Switching on the G-70
(1) Insert the included power cable into the AC inlet and
then plug it into an electrical outlet.
(2) Press the G-70's [POWER¥ON] button located on the
rear panel to switch it on.
(3) If you connected the G-70 to a mixing console, switch it on now.
(4) Switch on the amplifier, your active speakers or the keyboard amplifier(s).
(5) Use the [MASTER¥VOLUME] knob to set the G-70's out-
put volume.

Setting the display contrast

The information in the LCD display may be difficult to view
after turning on your G-70 or after extended use. Your
viewing angle or the current lighting conditions can also
affect the appearance of the display.
In such cases, use the [LCD¥CONTRAST] knob to the left of
the display to adjust the contrast.

Switching off the G-70

(1) Switch off all external devices.
(2) Use the G-70's [POWER≈ON] button to switch it off.
G-70 Music Workstation
VIDEO
OUTPUT
INTERNAL MEMORY
PROTECT
Note: Be sure to store the cap and the two screws in a safe
place in case you need them again at a later stage.
MASTER
VOLUME
r
Front panel
VIDEO
OUTPUT
INTERNAL MEMORY
PROTECT
21

Advertisement

Table of Contents
loading

Table of Contents