Table of Contents
Advertisement
POV.HD User Manual
Get Ready
2. Remove the Input/Output cover from the bottom of the recorder, and install the SD card
included with the POV.HD.
• Unscrew the retaining screw.
• The Input/Output cover has a snug, water-tight fit. To remove the cover, use a coin or
small flat bladed screwdriver to pry at either of the two arrows on the cover. DO NOT try
to remove the cover by pulling on the retaining screw.
• Insert the SD card, label side up into the card slot, until the card latches.
• Note that the SD card has a beveled corner on the leading edge. If you insert the SD
card upside down, the square corner will prevent the card from being fully inserted. DO
NOT force the card. If it will not go all the way into the slot, remove the card and make
certain the label is visible and the beveled corner is to the right.
• To remove the SD card when it is latched, push the back edge of the card slightly and it
will unlatch and project out about ⅛ inch. It can then be pulled out.
• Replace the Input/Output cover and tighten the retaining screw finger tight.
Note: The POV.HD comes with a 4 GB SD card. The POV.HD can use SD cards up to 32 GB
maximum.
3. Protect the recorder's LCD screen
To help protect the POV.HD recorder's LCD screen from scratches the POV.HD comes with
an LCD protective cover, which is a small plastic sheet that is used to cover the screen.
To install the LCD protective cover:
• The POV.HD is shipped with a temporary plastic film that protects the screen during
manufacture and shipping. If this is still on the unit remove it.
• Make sure the LCD screen is clean and free of any dust, smudges, fingerprints, and goo.
• Peel the paper off the back of the sheet and position the plastic sheet over the LCD
screen and press it down to secure it.
• Use your finger to smooth out any air bubbles that may be trapped under the cover.
Autogood products «130»
5
Advertisement
Table of Contents
