Check The Recorder And Camera Head; Set The System Time And Date - V.I.O POV.HD User Manual

POV.HD User Manual
Get Ready

Check the recorder and camera head

1. Press the Power button on the recorder. The recorder will take a few seconds to boot up.
2. When the recorder is ready, the LCD will show what the camera head is viewing, and the
upper left corner of the LCD will display the word "Standby", indicating that it is ready to
record.
3. If you see the preview from the camera head and the recorder displays "Standby",
everything is working as it should.
Possible issues:
a. The recorder won't power
• Are there batteries in the recorder? Don't be offended, it's happened to all of us.
b. When the recorder powers up, the LCD displays the message "No camera detected"
• The camera head cable may not be connected or it may not be seated properly.
Remove the cable completely, and try connecting again.
c. The camera comes up correctly, but no image is displayed on the LCD.
• Check to see that the camera head view isn't blocked. If it's under or behind something,
or you stuck it in your pocket, there may be nothing to see.
• Disconnect the camera cable and check to see that all the pins in the camera head
cable connector are straight and evenly spaced. Then reconnect the cable.

Set the System Time and Date

The time and date must be set in the recorder (one time only) so that video clips, still photos, and
other files will be correctly labelled.
1. Press the Settings button to go to the settings.
2. Navigate to Time and Date using the
3. When you reach the Time and Date menu, press the Select soft key.
4. The time and date are set one digit at a time. The ^ soft key increments the current digit
(colored red), and wraps at 9 to begin again at 0. The > soft key moves to the next digit to
the right, and wraps to the beginning after the last digit.
5. When the time and date are correct, press the Save soft key to store the time and date.
6. Press Play to enter Play-Preview mode. "Play" is displayed in the upper left of the LCD.
NOTE: If you do not power down the recorder before removing the batteries, the system time and
date will be cleared and you will need to set the time and date again, using this procedure.
:
up
and soft keys.
<< >>
Autogood products «130»
7