Check The Wireless Remote - V.I.O POV.HD User Manual

POV.HD User Manual
Get Ready

Check the wireless remote

1. With the recorder powered up and in Standby, and with the wireless remote within 5 feet of
the recorder, press REC/TAG on the remote.
2. The recorder should start recording. The word "Clip" will appear in the upper left corner of
the LCD, the upper right corner will be counting up the seconds that indicate the length of
the recording, and the LCD will show what is being recorded.
3. Press STOP on the wireless remote.
4. The recorder should stop recording and return to Standby.
If the wireless remote does not start and stop the recorder:
a. Move the remote closer to the recorder and try again.
b. Check to see that the recorder is in Standby. The word "Standby" should appear in the upper
left corner of the LCD. If the recorder is powered up but not in Standby:
• If the words "Still Photo" are displayed in the upper left of the LCD, you have left the
recorder in Still Photo. Go to the Settings menu and set the Recording Method to Clip.
See Settings
• Otherwise, press the REC button. If you are not in Standby or Still Photo, this will return
you to Record Standby.
c. Go to the Settings and check that the Remote Control ID is set to 0 (zero). If it is not, reset it
to 0.
The wireless remote will work up to 15 feet from the recorder, but to see that
i
it's working properly, it's best to have it close to the recorder to eliminate the
possibility of it being out of range or subject to unsuspected interference.
Your POV.HD is now ready to go.
below for instructions on how to do this.
Autogood products «130»
8