Web Services Configuration - Thecus N1200 User Manual

Channel
Auth Mode
WEP Enable
Key Length
WEP KEY 1
WEP KEY 2
WEP KEY 3
WEP KEY 4
A DHCP server can be configured to assign IP addresses to devices connected to
LAN ports.
WLAN DHCP Configuration
Item
DHCP Server
Start IP
End IP
DNS Server
NOTE
NOTE

Web Services Configuration

From the Network menu,
choose the Service item, and
the Web Service screen
appears. This screen displays
the service support
parameters of the system.
You can change any of these
items and press Apply to
confirm your settings. A
description of each item
follows:
The channel that the N1200 uses to communicate with client
devices.
Authentication mode used by the N1200.
Shared: Shared key authentication
Open: Open key authentication
Specifies whether to use encryption for transmission or not.
Key length specifies the level of encryption used by the N1200.
64 bit: 10 characters from 0 ~ 9 and A ~ F.
128 bit: 26 characters from 0 ~ 9 and A ~ F.
Input up to 4 WEP keys, and select the one you wish to use.
When connecting, be sure to enter the same key and select the
same index number on each client machine.
Description
Select to enable or disable DHCP server.
Specifies the starting IP address of the DHCP range.
Specifies the ending IP address of the DHCP range.
Specifies the DNS server IP address.
The IP Segment of WLAN, WAN and LAN should not overlap.
Users should obey the international RF regulatory rules as they set up the wireless
RF channel on the N1200. The RF operating channels for different regions have
been specified as following. Thecus has no responsibility for users attempting to
violate the international RF regulation.
11 N. America
14 Japan
13 Europe (ETSI)
2 Spain
4 France
28