Chapter 2: Getting Started; Overview; Before You Begin; Hard Disk Installation - Thecus N1200 User Manual

Chapter 2: Getting Started

Overview

Your N1200 is designed for complete ease-of-use. To help you get started, the
following chapter will help you get your N1200 up and running in no time. Please
read it carefully to prevent damaging your unit during installation.

Before You Begin

Before you begin, be sure to take the following precautions:
1. Read and understand the Safety Warnings outlined in the beginning of
the manual.
2. If possible, wear an anti-static wrist strap during installation to prevent
static discharge from damaging the sensitive electronic components on the
N1200.
3. Be careful not to use magnetized screwdrivers around the N1200's
electronic components.
4. The N1200 uses its chassis to dissipate heat. Please leave your N1200 in a
well-ventilated area to prevent overheating.

Hard Disk Installation

The N1200 supports a standard 3.5" or 2.5" Serial ATA (SATA) hard disk. To
install a hard disk into the N1200, follow the steps below:
1. Remove two screws from the sides of the unit with a Philips screwdriver.
2. Slide the top cover off, exposing the inside of the unit.
3. Remove the hard disk cage by unfastening four mounting screws.
4. Lift the hard disk cage out of the unit.
5. Carefully insert a standard 3.5" or 2.5" SATA hard disk into the cage, and
secure it with the hard disk mounting screws from the included accessory
pack.
6. Carefully lower the hard disk cage back into the N1200, making sure that
the tray is properly in place and then connectors are aligned.
7. Secure the hard disk cage with screws.
8. Replace the top cover and refasten the screws on both sides of the unit.

Cable Connections

To connect the N1200 to your network, follow the steps below:
1. Connect the unit's WAN port to your network hub or router with the
included RJ-45 Ethernet cable.
11