Inter-Tel CS-5200 Administrator's Manual page 58

Administrator Procedures
®
INTER-TEL CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
5.
Page 40
SION OPTION, press
ity-reversal supervision type. Or, press
Valid Call timer supervision. Or, press
for Valid Call timer with Polarity Reversal supervision. Then press
to continue.
Caller ID: To enable or disable Caller ID, press
ton. When the display shows SET CALLER ID, press
or OFF to disable it. Then press
ture, or press
2
Hybrid Balance: To set the hybrid balance of the trunk to normal or short, press
or the
HYBRID BALANCE
ANCE OPTION, press
SHORT menu button. Then press
DTMF/Dial-Pulse Signaling: To set the trunk for DTMF or dial-pulse signaling,
press or the
SIGNALING
4
NALING OPTION, press
menu button. Then press
Trunk Group Number: To assign the trunk to a trunk group, press
menu button. When the display shows ENTER TRUNK GRP EXTEN-
GROUP
SION, enter the desired trunk group number using one of the methods described on
page 39.
Busy Trunk: To temporarily remove the trunk from service, press
TRUNK menu button. When the display shows MARK TRUNK BUSY, press
or the ON menu button, or press
to continue.
ACCEPT
c. To exit, press or
#
reach the ENTER DATABASE OPTION prompt.
To Program A Trunk Group: Press
program the trunk group, as follows:
a. The display shows ENTER TRUNK GRP EXTENSION. Enter the extension num-
ber of the trunk group to be programmed using one of the methods described on
page 39.
b. The display shows ENTER TRUNK GROUP OPTION. Select one of the following
options. To view the last three options on a display phone, press the arrow (<< or
>>) menu button at the bottom of the display.
Answer Access For Day Or Night Mode: To program the endpoint(s) that will
have answer access for this trunk group for day mode, press
menu button. To program for night mode, press
ACCESS DAY
ACCESS NIGHT menu button. When the display shows ENTER ENDPOINT
EXTENSION, perform the procedure described on the following page.
1.) Enter a endpoint extension using one of the methods described on
2.) The display shows the extension number and a Yes/No prompt. To include the
endpoint in the list, press
exclude the endpoint from the list, press
by .
#
3.) When the display returns to ENTER ENDPOINT EXTENSION, select
another extension number. Or, if finished programming the endpoint list, press
or ACCEPT to continue.
#
or the POLARITY REVERSE
1
or the
2
or the
3
menu button. When the display shows HYBRID BAL-
or the menu button, or press
NORMAL
1
or ACCEPT
#
menu button. When the display shows ENTER SIG-
or the DTMF menu button, or press
1
or ACCEPT to continue.
#
or the OFF menu button. Then press
2
to move backward through the prompts until you
ACCEPT
or the TRUNK GROUP menu button. Then
2
or the YES menu button, followed by
1
2
menu button for the polar-
menu button for
VALID CALL
menu button
VALID + POLARITY
or
ACCEPT
#
or the menu but-
CALLER ID
2
or to enable the fea-
ON
1
or ACCEPT to continue.
#
2
to continue.
or the PULSE
2
or the
TRUNK
5
or the
6
or the
1
or the
2
page 39.
#
or the NO menu button, followed
Trunk Programming
3
or the
BUSY
1
or
#
ANS-
ANS-
. Or, to