Inter-Tel CS-5200 Administrator's Manual page 49

INTER-TEL
Figure 1.
Endpoint Database Programming Flowchart
Press 1 or ENDPOINT FLAGS
menu button
Select flag to program
Press 1 or
ON menu button
to enable
AT ANY LEVEL:
Press * or the Speaker button to cancel any un-
saved changes and back up to exit program-
ming.
Press # or ACCEPT to save changes and back
up one display level.
INFORMATION IN THIS CHART IS SHOWN
AS FOLLOWS:
Endpoint Database Programming Flowchart
®
CS-5200/5400 ADMINISTRATOR GUIDE, ISSUE 1.1 – August 2005
Enter Program Database
feature code 9932
ENTER DATABASE OPTION
Press 1 or ENDPOINT
menu button
ENTER ENDPOINT EXTENSION
Enter desired endpoint extension number, then #
ENTER ENDPOINT OPTION
Press 2 or ENDPOINT INFO
menu button
ENDPOINT INFO OPTION
Press 1 or
ATTENDANT
Press 2 or
menu button
OFF menu button
to disable
Enter
Attendant's
extension
YOUR INPUT
ENDPOINT DISPLAYS
Administrator Procedures
Press 3 or TOLL RESTRICTION
TOLL RESTRICTION OPTION
Press 2 or
Press 1 or COS
USERNAME DAY menu button
for day mode
menu button
SET DAY/NIGHT COS XX
Enter
new
username
If necessary, select COS number
to program by scrolling
Press 1 or
ON menu button
to enable COS
If desired, select another COS number
to program by scrolling
menu button
Press 2 or COS
NIGHT menu button
for night mode
Press 2 or
OFF menu button
to disable COS
Page 31