Putting Into Storage - Gardena 380 AC Operating Instructions Manual

Switching off the cylinder
mower :
Adjusting the cutting height:
K
K
Mowing with the grass
collection sack
(accessories) :

5. Putting into Storage

Storage :
Disposal :
(in accordance with
RL 2002 / 96 / EC)
16
Note : The accu cylinder mower can be operated with the Accu
or without as a hand mower.
The key prevents the cylinder mower being switched on
accidentally.
1. Release starting handle
2. Remove the safety key each time you stop work.
DANGER ! Cutting tool can cause injuries !
A
V When adjusting the cutting height, remove the key
The cutting height can be set to any
position between 12 mm and 42 mm.
1. Stand behind the cylinder mower
with one foot on the roller
2. Slacken the two locking screws
and set to the height required on
the scale
3. Tighten the two locking screws
on both sides to the same height.
The locking screws
J
both sides.
The mower may only be adjusted to a depth in which the lower
blade does not touch the ground when it is uneven.
v Suspend the grass collection sack in the cylinder mower
as described in the Operating Instructions.
1. Remove safety key.
2. Clean mower before storage and connect to the charger (see 5.
Maintenance).
3. Store mower in a dry, frostproof but cool place out of reach of
children.
To save space, the cylinder mower can be folded up by folding
the clamping lever. Ensure the cable is not trapped during this
process.
If the mower is not stored connected constantly to the charger, the
Accu must be charged at least every six months because it self-
discharges. Self-discharging is reduced at low storage temperatu-
res.
If the Accu is completely flat, e.g. due to too long storage without
any recharge, it will get its full efficiency again after several char-
ging cycles.
The product must not be added to normal household waste. It
must be disposed of properly.
I
.
and wear suitable work gloves.
J
.
L
.
K
must always be set to the same height on
K
K
L