Putting Into Storage; Maintenance; Troubleshooting - Gardena 300 Operating Instructions Manual

Adjusting the cutting height :
6
5
6

5. Putting into Storage

Storage :

6. Maintenance

Cleaning the mower :

7. Troubleshooting

10
The cutting height can be set to any
position between 12 mm and 42 mm.
1. Stand behind the cylinder mower
with one foot on the roller
2. Release the two locking screws
and adjust to the correct height in
the inspection window
3. Tighten the two locking screws
height.
6
The locking screws
both sides.
The mower may only be adjusted to a depth in which the lower
blade does not touch the ground when it is uneven.
v Clean cylinder mower before storage (see 5. Maintenance) and
store in a dry place.
The cylinder mower can be collapsed to save space by relea-
sing the wing nuts on the upright.
DANGER ! Cutting mechanism can cause injuries !
V Wear suitable work gloves when undertaking
maintenance.
Always keep the cylinder mower clean and remove grass deposits.
Deposits affect the cutting result as well as discharge of grass
clippings. Residual dirt and grass is easily removed immediately
after mowing.
1. Remove grass deposits with a brush and a cloth.
2. Oil the red cutting mechanism lightly with thin oil (e.g.
sprayed oil).
DANGER ! Cutting tool can cause injuries !
V Wear suitable work gloves when rectifying faults.
5
.
6
7
.
6
on both sides to the same
must always be set to the same height on
7