Putting Into Storage; Maintenance - Gardena 300 C Operating Instructions Manual

Adjusting the cutting height :
9
9

5. Putting into Storage

Storage :

6. Maintenance

Cleaning the mower :
10
After relatively long intervals between mowing (e.g. holiday), first of
all cut in one direction with the cutting height as high as possible
(42 mm), then cut in the crosswise direction at the cutting height
required. The blades of grass should not be more than 12 cm
long if they are to be cut with a cylinder mower.
If possible only cut the grass when it is dry. If the grass is damp,
the cutting pattern will be uneven.
The cutting height can be set to any
position between 12 mm and 42 mm.
1. Stand behind the cylinder mower
with one foot on the roller
2. Slacken the two locking screws
and set to the height required on
the scale
3. Tighten the two locking screws
on both sides to the same height.
The locking screws
both sides.
8
The mower may only be adjusted to a depth in which the lower
blade does not touch the ground when it is uneven.
v Clean cylinder mower before storage (see 6. Maintenance) and
store in a dry place.
To save space the cylinder mower can be collapsed by opening
up the clamping nuts.
DANGER ! Cutting mechanism can cause injuries !
V Wear suitable work gloves when undertaking
maintenance.
WARNING ! Damage to cylinder lawnmower.
A
V Never clean your cylinder lawnmower with running
Always keep the lawnmower clean and remove grass deposits.
Deposits affect the cutting result as well as discharge of grass
clippings. Residual dirt and grass is easily removed immediately
after mowing.
1. Remove grass deposits with a brush and a cloth.
2. Oil the red cutting mechanism lightly with thin oil (e.g. sprayed
oil).
8
.
0
.
9
must always be set to the same height on
water, in particular with water under high pressure.
9
9
0