Table of Contents
Advertisement
4. Operation
Mowing correctly:
Adjusting the cutting height:
0
9
5. Putting into Storage
Storage:
10
To produce a well-maintained lawn we recommend cutting the
lawn regularly once a week if possible. The lawn becomes thicker
if cut frequently.
Relatively long cut grass (> 1 cm) must be removed so that the
lawn does not become yellow and matted.
After relatively long intervals between mowing (e. g. holiday),
first of all cut in one direction with the cutting height as high as
possible (42 mm), then cut in the crosswise direction at the
cutting height required. The blades of grass should not be more
than 12 cm long if they are to be cut with a cylinder mower.
If possible only cut the grass when it is dry. If the grass is damp,
the cutting pattern will be uneven.
The cutting height can be set to any position from 12 mm
to 42 mm in 4 steps.
1. Lay the mower onto the
ground, so that it cannot fall
over when adjusting the cut-
ting height.
2. Pull both height adjustment
9
mechanisms
and allow
them to engage at the required
0
height on the scale
The height adjustment mechanisms
same height on both sides.
CAUTION! The mower may only be adjusted to a depth
in which the lower blade does not touch the ground when
it is uneven.
v Clean cylinder mower before storage (see 6. Maintenance) and
store in a dry place.
To save space, the upright can be collapsed by opening up the
clamping nuts.
.
9
must always be set to the
Advertisement
Table of Contents
