Putting Into Storage; Maintenance - Gardena 380 EC Operating Instructions Manual

Adjusting the cutting height :
H
Mowing with the grass
collection sack
(accessories) :

6. Putting into Storage

Storage :
Disposal :
(in accordance with
RL 2002 / 96 / EC)

7. Maintenance

Note: The cylinder mower can be used in electric mode or as a
push-lawnmower without the electric drive.
DANGER ! Cutting tool can cause injuries !
A
V When adjusting the cutting height, wait until the
blade cylinder is stationary, put on suitable working
gloves and unplug from the mains.
The cutting height can be set to any
position between 12 mm and 42 mm.
1. Slacken the two locking screws
and set to the height required on
I
the scale .
2. Tighten the two locking screws
on both sides to the same height.
H
The locking screws
be set to the same height on both sides.
The mower may only be adjusted to a depth in which the lower
blade does not touch the ground when it is uneven.
v Suspend the grass collection sack in the cylinder mower
as described in the Operating Instructions for the grass
collection sack.
1. Switch off the lawnmower and pull out the extension cable.
2. Clean mower before storage (see 7. Maintenance).
3. Store mower in a dry, frostproof but cool place out of reach of
children.
To save space, the cylinder mower can be folded up by folding
the clamping lever.
The product must not be added to normal household waste. It
must be disposed of in line with local environmental regulations.
DANGER ! Cutting tool can cause injuries !
V Before maintenance, wait until the cutting tool is
stationary, wear suitable work gloves and pull out the
mains plug.
DANGER ! Injury to persons and damage to property !
V Do not clean mower under running water (especially
at high pressure).
H
H
must always
I
15