Canon R-F10 Operation Manual page 38

INC
COUNT
[No.]
DATE
ORDER
AUTO MEASURE
R–L MEASURE
6.1 Settings for Measurement (Page: 1/3)
Increment of sphere and cylinder "
Whether to display and print the serial number
" ON ": Serial number will be displayed on the monitor and printed
with the result. It counts up at the measurement after the
print.
" ": Serial number will neither be displayed nor printed.
OFF
"5-digit number": Serial number
[How to change the number]
(1) Turn the roller, or press
digit. The number of the selected digit will be displayed in
reverse image.
(2) The number increases when
creases when
START
" ": Resets serial number to "
RESET
[How to reset]
(1) Turn the roller, or press
SET ".
(2) Press switch or
START
Date and time
" 01 " – " 31 ":
" " – " ":
JAN DEC
" " – " ":
2000 2099
" " – " ":
00 23
" " – " ":
00 59
[How to change the setting]
(1) Select the item by turning roller, or by pressing
switch.
(2) Number increases when
when switch is pressed.
START
Order of displaying the date
" ": Year, month, day
YMD
" ": Month, day, year
MDY
" ": Day, month, year
DMY
The number of continuous measurements "
Whether to make a series of measurements on both eyes automatically
" ": Left eye will automatically be measured after measuring the
ON
right eye.
– 26 –
,
0.12 0.25
switch or
IOL VD
PRINT switch is pressed, and de-
switch is pressed.
".
00001
switch or
IOL VD
switch.
PRINT
Day
Month (When "YMD" is selected for "
below, month will be displayed in numbers "
– " ")
12
Year
Hour
Minutes
switch is pressed, and decreases
PRINT
1 / 3 / 5
"
switch to select the
switch to select "
RE-
ORDER
switch or
IOL VD
"
"
"
1