Canon R-F10 Operation Manual page 25

1
Check that automatic measurement has been chosen
If the words "
FULL AUTO
displayed on the monitor, press
switch.
2
Check that the examinee's eye is displayed on the monitor
If you cannot see it at all, adjust the
position of the measurement head
using the trackball.
Measurement head moves to right and
left when trackball is turned to right
and left.
Measurement head moves up and
down when it is turned back and forth.
3
Have the examinee look at the eye fixation target
Have the examinee look at the red roof in the center of the scene shown.
4.2 Measurement in FULL AUTO Mode
" is not
AUTO
– 13 –
PD: – – VD:13.5
FULL AUTO(3)
RIGHT SPH CYL
1:
PD: – – VD:13.5
FULL AUTO(3)
RIGHT SPH CYL
1:
No. 00001
AX
No. 00001
AX