Canon R-F10 Operation Manual page 22

When the checks are completed,
FULL AUTO mode will be selected
and the measurement head will move
and stop at the right eye side.
NOTE: Because the measurement
head moves during initializa-
tion, do not have the examinee
place his/her face on the chin
rest until the initialization is
completed.
2
Check the settings
Check and change the settings concerning measurement and printing as required (→
sections 6.1 – 6.2).
If you want to print a message with the result, enter it (→ sections 6.3).
Vertex distance can be selected by
pressing the VD
Each time the switch is pressed,
vertex distance changes (12.0 or 13.5,
whichever is selected in SET mode →
0.0 →12.0/13.5 → 0.0...), and result
changes accordingly.
4.1 Preparation
switch.
– 10 –
PD: – – VD:13.5
FULL AUTO(3)
RIGHT SPH CYL
1:
0.0
PD: – – VD:13.5
FULL AUTO(3)
RIGHT SPH CYL
1:
No. 00001
AX
No. 00001
AX