Remote Control Codes For Integra/Onkyo Components Connected Via; Resetting The Remote Mode Buttons; Resetting The Remote Controller - Integra DTR-8.8 Instruction Manual

Controlling Other Components—Continued
Remote Control Codes for Integra/Onkyo
Components Connected via
Integra/Onkyo components that are connected via
are controlled by pointing the remote controller at the
AV receiver, not the component. This allows you to con-
trol components that are out of view, in a rack, for exam-
ple.
1 Make sure the Integra/Onkyo component
is connected with an
analog audio cable (RCA).
See page 45 for details.
2 Enter the appropriate remote control code
to the Remote Mode button.
• [DVD] Remote Mode button
5002: Integra/Onkyo DVD player with
• [CD] Remote Mode button
6002: Integra/Onkyo CD player with
• [MD] Remote Mode button
6008: Onkyo MD recorder with
• [CDR] Remote Mode button
6006: Onkyo CD recorder with
• [Dock] Remote Mode button
6004: Onkyo RI Dock DS-A1 with
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want
to control an Integra/Onkyo component that's not con-
nected via , use the following remote control codes:
• [DVD] Remote Mode button
5001: Integra/Onkyo DVD player without
(default)
• [CD] Remote Mode button
6001: Integra/Onkyo CD player without
(default)
• [MD] Remote Mode button
6007: Onkyo MD recorder without
• [CDR] Remote Mode button
6005: Onkyo CD recorder without
• [Dock] Remote Mode button
6003: Onkyo RI Dock DS-A2 without
Note:
• If you connect an

Resetting the Remote Mode Buttons

You can reset a Remote Mode button to its default
remote control code.
cable and an
1
CDR/MD/Dock
2
CDR/MD/Dock
You can reset the remote controller to its default settings.
1
2
(default)
-capable Onkyo MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote oper-
ation to work properly, you must set the Input Display
to MD or CDR, respectively (see page 52).
While holding down the Remote
Mode button that you want to
Remote Mode
reset, press the TV [
DVD VCR
The Remote indicator flashes three
CD TV
times.
Cable Net/USB
SAT
TV
Press the Remote Mode button
again.
Remote Mode
The Remote indicator flashes twice,
DVD VCR
indicating that the button has been
CD TV
reset.
Net/USB
Cable
The [DVD] and [CD] Remote Mode
SAT
buttons are preprogrammed with
remote control codes for controlling
Integra/Onkyo DVD players and CD
players, respectively. When these but-
tons are reset, the preprogrammed
codes are restored.

Resetting the Remote Controller

While holding down the
[Receiver] Remote Mode button,
Receiver
press the [Standby] button.
The Remote indicator flashes five
times.
Standby
Press the [Receiver] Remote
Mode button again.
Receiver
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.
] button.
133