Speaker Distance - Integra DTR-8.8 Instruction Manual

Advanced Setup—Continued

Speaker Distance

These settings are set automatically by the Automatic
Speaker Setup function (see page 55).
With the Speaker Distance settings, you can specify the
distance from each speaker to the listening position.
1
Press the [Receiver] Remote
Mode button, followed by the
Receiver
[Setup] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "2. Speaker
Setup," and then press [Enter].
Enter
The Speaker Setup menu appears.
2.Speaker Setup
Enter
3
Use the Up and Down [
buttons to select "3. Speaker Dis-
tance," and then press [Enter].
Enter
The Speaker Distance screen appears.
2-3.Speaker Distance
Enter
Note:
• Speakers that you set to No or None
in the Speaker Configuration
(page 101) cannot be selected.
104
1.Speaker Settings
2.Speaker Config
3.Speaker Distance
4.Level Calibration
5.Equalizer Settings
6.THX Audio Setup
Unit
Left
Center
Right
Surr Right
Surr Back R
Surr Back L
Surr Left
Subwoofer
4
Enter
Enter
5
Enter
]/[ ]
Enter
]/[ ]
feet
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
12.0ft
6
12.0ft
7
Note:
• This procedure can also be performed on the AV
receiver by using its [Setup], [Enter], and arrow but-
tons.
Use the Up and Down [
buttons to select "Unit," and then
use the Left and Right [
buttons to select:
feet: Select if you want to enter
distances in feet. Can be set
from 0.2 to 30 feet in 0.2-foot
steps.
meters: Select if you want to enter
distances in meters. Can be
set from 0.06 to 9 meters in
0.06-meter steps.
Use the Up and Down [
buttons to select a speaker, and
use the Left and Right [
buttons to specify the distance.
Specify the distance from the speaker
to your listening position.
Notes:
• The Center distance cannot be set if
Speaker Type is set to BTL (page 47)
or Center is set to None in the
Speaker Configuration (page 101).
• The Surr Right and Surr Left dis-
tances cannot be set if Speaker Type
is set to BTL (page 47) or Surround
is set to None in the Speaker Config-
uration (page 101).
• The Surr Back R and Surr Back L
distances cannot be set if Speaker
Type is set to Bi-Amp or BTL
(page 47), Surr Back is set to None in
the Speaker Configuration
(page 101), or Powered Zone 2 is
being used (page 126).
• The Subwoofer distance cannot be
set if Subwoofer is set to No (step 4).
Repeat step 5 for each speaker.
Press the [Setup] button.
Setup closes.
]/[ ]
]/[ ]
]/[ ]
]/[ ]