Table Of Contents; Quick Reference - NCR 7156 Service Manual

Quick Reference

This Quick Reference will direct you to key areas of the Service Guide. For a complete
listing of topics, consult the Table of Contents or the Index.
Setting Up the Printer
Checking and Adjusting the MICR Check Reader
Running the Data Scope Mode
Troubleshooting
Adjusting the Platen Gap
Replacing the Thermal Printhead
Replacing the Knife Assembly
Basic requirements for unpacking and installation, connecting the printer, turning
it on, and running the print test.
Instructions for adjusting the Magnetic Ink Character Recognition (MICR) check
reader for the common PC board and the MICR amplifier board (on older
LCSIO-RS-485 models).
Instructions for running the data scope mode.
Information on correcting problems with the printer.
Instructions for adjusting the platen gap on the print mechanism.
Instructions for replacing the thermal printhead on the thermal mechanism.
Instructions for replacing the knife assembly on the thermal mechanism.
September 1998
page 7
pages 27, 30
page 35
page 43
page 55
page 72
page 74
v