Assembly; Remove The Generator From The Shipping Carton; Add Engine Oil - Champion Power Equipment 73536i Owner's Manual & Operating Instructions

ASSEMBLY

Your generator requires some assembly . This unit ships
from our factory without oil . It must be properly serviced
with fuel and oil before operation .
If you have any questions regarding the assembly of your
generator, call our help line at 1 (877) 338-0999 . Please
have your serial number and model number available .

Remove the Generator from the Shipping Carton

1 . Set the shipping carton on a solid, flat surface .
2 . Remove everything from the carton except the
generator .
3 . Using the handle of the unit, carefully remove the
generator from the box .

Add Engine Oil

CAUTION
DO NOT attempt to crank or start the engine before
it has been properly filled with the recommended
type and amount of oil . Damage to the generator as
a result of failure to follow these instructions will
void your warranty .
1 . Place the generator on a flat, level surface .
2 . Loosen the cover screw and remove the maintenance
cover .
3 . Remove oil fill cap/dipstick to add oil .
7
REV 73536i-20110121
Add Engine Oil Cont'd.
4 . Add 0 .42 qt (0 .4 L) of oil and replace oil fill cap/
dipstick . Check engine oil level daily and add as
needed .
5 . Check engine oil level daily and add as needed .
CAUTION
The engine is equipped with a low-oil-shutoff and
will stop when the oil level in the crankcase falls
below the threshold level .
NOTE
The recommended oil type is 10W-30 4-cycle
automotive oil .
NOTE
Check oil often during the break-in period . Refer to the
Maintenance section for recommended service intervals .
73536i
ENGLISH