Table of Contents
Advertisement
Assembly
Your generator requires some assembly.
This unit ships from our factory without oil.
It must be properly serviced with fuel and oil
before operation.
If you have any questions regarding the
assembly of your generator, call our help
line at (877) 338-0999. Please have your
serial number and model number available.
Remove the Generator from
the Shipping Carton
1.
Set the shipping carton on a solid, flat
surface.
2. Remove everything from the carton
except the generator.
3. Carefully cut each corner of the box
from top to bottom. Fold each side flat
on the ground to provide a surface area
to install the wheel kit and support leg.
Install the Wheel Kit
CAUTION
The wheel kit is not intended for over-the-road
use.
You will need the following tools to install
the wheels:
12 mm wrench
Socket wrench with a 12 mm socket
Pliers
1.
Before adding oil to the engine, tip the
generator slowly so that the engine side
is up.
2. Slide the axle through both mounting
brackets.
3. Place an "o" washer onto the axle and
then slide a wheel onto the axle. Make
certain that the valve stem is facing
outward.
4. Place a flat washer on the end.
5. Install the cotter pin through the hole on
the end of the axle.
6. Carefully bend the legs of the cotter pin
back around the axle.
7. Repeat steps 3-6 to attach the second
wheel.
Install the Support Leg
1.
Attach the rubber vibration mount to
the support leg with a cap screw
(M8x20) and lock nut (M8).
2. Attach the support leg to the generator
frame with cap screws (M8x30) and lock
nuts (M8).
3. Tip the generator slowly so that it rests
on the wheels and support leg.
Install the Handle
1.
Line up the bottom hole on the handle
with the bottom hole on the frame.
2. Place a plastic washer on the cap screw
(M8x50) and thread through the frame
and handle.
3. Place a plastic washer and lock nut (M8)
on the end of the bolt and fasten
securely. DO NOT over tighten the lock
nut.
4. Wrap the retention cord around the
frame near the handle. Thread the lock
pins through the loop on the retention
cord.
5. Repeat steps 1-4 for the second handle.
Connect the Battery
1.
Place the battery in the battery
mounting channel.
2. Hook one J-bolt through the hole on the
bottom left side of the battery mounting
channel.
3. Place a washer on the J-bolt and fasten
loosely with the wing nut.
4. Repeat steps 1-2 for the right side of the
battery mounting channel.
5. Tighten both wing nuts evenly and
securely.
6. Remove the protective cover from the
red battery lead.
7. Attach the red lead to the red terminal
on the battery with the cap screw
(M6x20) and secure with the lock
washer (M6)
8. Repeat steps 5-6 for the black battery
lead.
Assembly
9
Advertisement
Table of Contents
