Miso Disconnect Jumper (P6); Sma Connector Clock Disconnect Jumper (P10) - Analog Devices SHARC 82-000805-01 Manual

MISO Disconnect Jumper (P6)

The signal of the serial peripheral interconnect (SPI) connector (
MISO
is driven by a buffer to the processor's
Figure 2-1 on page
jumper to prevent the signal from interfering with other devices on the
P6
SPI bus.

SMA Connector Clock Disconnect Jumper (P10)

The SMA connector (
from other clock source. The input signal is directed though a buffer, as
illustrated in Figure 2-1 on page
use, remove the
nals on the net.
SHARC EZ-Extender Manual
EZ-Extender Hardware Reference
2-2. When the SPI connector is not in use, remove the
) enables a clock input from a signal generator or
J3
2-2. When the SMA connector is not in
jumper to prevent the buffer from driving other sig-
P10
signal, as illustrated in
MISO
)
J2
2-5