Breadboard Area - Analog Devices SHARC 82-000805-01 Manual

Breadboard Area

Switch (SW1)" on page
and
DAI_P15_GP1
evaluation board being interfaced; therefore, the board's model must be
taken into consideration.
The data bus of the EZ-Extender must be enabled before data is read.
Enable the data bus by a memory read from address
the pins set up as the external port. Then, the
AD[15:0]
be set up in PDAP mode.
A list of ADC boards compatible with the extender can be found at
http://www.analog.com/processors/processors/blackfin/technicalL-
ibrary/manuals/pdf/EZ-Extender_to_DSP_Supported.pdf
Technical Support for information about available examples. To learn
more about Analog Devices data converters, go to
Breadboard Area
SHARC EZ-Extender broadens the range of the EZ-KIT Lite applications
by providing surface mounted (SMT) footprints for breadboard capabili-
ties and access to all of the pins on the EZ-KIT Lite's expansion interface.
1-2
2-3. The setup of the general-purpose signals
is dependent on the specific ADC HSC
DAI_P16_GP2
0x160 0000
AD[15:0]
. Contact
www.analog.com
SHARC EZ-Extender Manual
, which
pins can
.