Care And Maintenance; Humidity Control - CDA CWC600SS User Manual

Care and Maintenance

Removing Shelves
• To remove any of the shelves from the rail
compartment, remove the plastic stops on
either side of the shelf by unscrewing the
Phillips screws that holds each post in place.
Please ensure these are replaced when the
shelf is put back.

Humidity Control

The wine cooler is equipped with a system for
maintaining the correct level of humidity. Fill the
small plastic reservoir (humidity box) ¾ full with
water, and fit onto the runners found on the top
shelf of the wine cooler. Check the water level
regularly and refill as necessary.
Please ensure the reservoir is positioned correctly
on the runners on the top shelf to avoid the
possibility of water spillage.
See figure "AA"
FIG "AA"
Replacing Your Light Bulb
NOTE:
Before removing the light bulb, turn off
the appliance and disconnect from the
power supply. Failure to do so could
result in electrical shock or personal
injury.
• Turn off the light.
• Remove the screw
screwdriver.
• Pull down to remove the lamp cover .
• Unscrew the bulb .
• Replace with a 15-watt bulb that is the same
shape and size.
• Replace the lamp cover
1 2
3 4
Lamp Cover
Screw
Top
Note: The bulb should not exceed 15
watts.
9
with a Phillips
and tighten screw .
5
Interior Section
Bulb
Lamp Holder
6