Important information losses caused by incorrect use or installation of this product. Before first use Please note that The CDA Group reserve the right to invalidate the Use and controls guarantee supplied with this product following incorrect installation or misuse of the appliance or use in a commercial environment.
Appliance information: • Repairs carried out by unqualified persons may seriously Please enter the details on the appliance rating plate below for reference, to assist Customer Care in the event of a fault with your endanger the appliance user appliance and to register your appliance for guarantee purposes. •...
Before first use You must allow the appliance to settle for at least twenty four • Only store wine in sealed containers hours prior to switching the power on. • Do not overload the cabinet • Only open the door when necessary It is recommended that you remove all internal and external •...
12-20°C for the lower zone (right display). Temperature display button “+” button “-” button To change the temperature reading - WCCF0302 & WCCF0152 & Zone selection WCCF0622 To lock/unlock the control panel - all models You can change the temperature display reading from Fahrenheit to •...
Page 6
Optimal temperature selection • A decimal point ‘.’ next to the temperature signifies that Below is a table showing the recommended storage temperatures the wine cooler is working to achieve the set temperature. for different types of wine. These are also the ideal drinking When the decimal point disappears, or if it is not present, the temperatures for most types.
If you have any problems with your appliance, you should check • Clean the shelves separately by hand using soap and water. Do not the troubleshooting guide prior to calling CDA Customer Care. put them in the dishwasher. • Ensure that the cloth is only moist when cleaning the...
• of the worktop (6 mm or ¼”). Please note: The LED lighting cannot be replaced without a service call. If the light fails, contact CDA Customer Care. 14 | Instruction Manual Instruction Manual | 15...
These products should not be installed: 1. Peel back the door seal from the glass side to expose the screw holes, as per Fig. 4. Place a screwdriver against the 1. In direct sunlight. screw and hold it in position. 2.
Page 10
1. With the help of another, open the 7. Guide the door onto the upper door and support it. Loosen and hinge pivot and manoeuvre the remove the two screws from the lower part of the door and pivot pivot plate of the lower right hinge, plate onto the lower hinge.
Page 11
Fitting the plinth The plinth/grille for this appliance comes packaged inside and can be fitted if desired. Follow these steps to do so: 1. Locate the plinth (packaged inside the appliance) 2. Remove the four screws from (two on each side of) the plinth section, but take care to support both sections to prevent the adjustable section from falling away.
Electrical information 8. Adjust the wine cooler feet so that you achieve the desired height for the cooler. If needed, re-attach the extendable plinth Warning! This appliance must be earthed. section with the four screws that were removed in step 2. Stand the wine cooler up steadily - if the extendable section will foul the floor or similar, remove it.
How to connect an alternative plug Quiet mode If the fitted plug is not suitable for your socket outlet, then it should This appliance has a quiet mode. Whilst active, and once the set be cut off and disposed of safely to avoid possible shock hazard. A temperature is reached, the appliance slows down the internal suitable alternative plug of at least 13 Amp rating to BS 1363 should fan(s) to reduce the running noise.
Climate Range The information about the climate range of the appliance is WCCF0152 WCCF0302 provided on the rating plate. It indicates at which ambient temperature (that is room temperature in which the appliance is working) is optimal for the operation of the appliance.
Need help?
Do you have a question about the WCCF0152 and is the answer not in the manual?
Questions and answers