Attaching Handle (Honey Bee); Installing Safety Flag; Installing Cover - Burley Bee Owner's Instruction And Safety Manual

Attaching Handle (Honey Bee)

1. Slide handle into lower handle bar receivers and tighten
knobs. To change height position, flip handle over. Figure 10
Handlebar
Handlebar
Installation
Knob
2. Around center of handlebar, slide tether strap end through
small loop on other end of strap and tighten securely. Photo 2
 |
B U R L E Y C H I L D T R A I L E R O W N E R ' S I N S T R U C T I O N A N D S A F E T Y M A N U A L
Flag
Flag Installation
Hole
Photo 2

Installing Safety Flag

Bee
Join two flag sections together. On outer left side of trailer,
insert flag pole into flag pocket.
Honey Bee
Insert flag pole into hole in top of
IMPORTANT:
DO NOT USE TRAILER WITHOUT SAFETY FLAg.

Installing Cover

Snap cover onto top of frame.
Bee:
At top of frame, stretch elastic loops around
Honey Bee:
handlebar mounts.
Attach cover to trailer front and back with fastener strips
Both:
and O-rings.
handle bar receiver. Figure 10
LEFT