Cisco Small Business AP541N Administration Manual page 53

4
48
Table 10 Radio Settings Field Descriptions
Field Description
The country in which the access point is operating.
Country
Wireless regulations vary from country to country. Make sure
you select the correct country code so that the access point
complies with the regulations in your country. The country
code selection affects the wireless radio modes the access
point can support as well as the list of channels and transmit
power of the wireless radio.
Enabling support for IEEE 802. 1 1d (World Mode) on the access
802.11d
Regulatory point causes the access point to broadcast which country it is
Domain
operating in as a part of its beacons and probe responses. This
Support
allows client stations to operate in any country without
reconfiguration.
Disabling 802. 1 1d prevents the country code setting from
being broadcast in the beacons. However, this only applies to
wireless radios configured to operate in the
band). For wireless radios operating in the
band), the access point software configures support for
802. 1 1h. When 802. 1 1h is supported, the country code
information is broadcast in the beacons.
To enable 802. 1 1d regulatory domain support, click Enabled.
To disable 802. 1 1d regulatory domain support, click Disabled.
Turns the wireless radio interface on or off.
Wireless
Radio
Interface
Indicates the Media Access Control (MAC) addresses for the
MAC Address
interface.
This page shows the MAC addresses for Radio Interface One.
A MAC address is a permanent, unique hardware address for
any device that represents an interface to the network. The
MAC address is assigned by the manufacturer. You cannot
change the MAC address. It is provided here for informational
purposes as a unique identifier for the interface.
Cisco AP541N Dual-band Single-radio Access Point Quick Start Guide
Modifying Wireless Radio Settings
g
band (2.4 GHz
a
band (5 GHz
Wireless