Charcoal Filter; Light Bulbs; Stainless Steel Hood Surfaces - Monogram ZV830 Owner's Manual

Charcoal filter

If the model is not vented to the outside, the
air will be recirculated through a disposable
(on some models)
charcoal filter that helps remove smoke and odors.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to 12
months, depending on hood usage).
NOTE: DO NOT rinse, or put charcoal filter in an
automatic dishwasher.
The charcoal filter cannot be cleaned. It must be
replaced.
Order Charcoal Filter WB02X11348.
To inquire about purchasing replacement charcoal
filters or to find the location of a dealer nearest you,
please call our toll-free number:
National Parts Center
Stainless
Regularly polish the stainless steel exterior
with Stainless Steel Magic
steel hood
polishing cloth, to preserve and protect the
surfaces
fine finish.
To avoid scratching the fine finish of the
stainless steel, wipe in the same direction as the
grain when polishing or cleaning any stainless
steel surface.
For regular cleaning, use clean water and a soft
cloth. If stains persist, wash with mild dish soap
using a soft cloth or nonabrasive pad. For more
difficult stains, make a solution consisting of
25% vinegar (white or red) and 75% water. Dip
a soft cloth into the solution and rub onto the
stainless steel to remove the stain. If these
methods do not remove the stains, dirt or
debris, call 800.GE.CARES.

Light bulbs

touching.
To change the light bulbs:
1. Press and turn the light bulb face 1/4 turn.
2. The bulb will drop straight out.
3. Replace with the same size bulb by placing bulb
™ and the Monogram
CAUTION:
Allow bulbs to cool before
prongs into the keyhole slots and turning 1/4
turn to lock in place.
These 120 volt, 50 watt, MR16 halogen bulbs
with GU10 bases are available at most specialty
lighting stores, building centers and large
retailers. Ask for MR16 GU10 base bulb.
Care and Cleaning
To remove:
1. Remove the metal filter—see Metal grease filter
section.
2. Remove the charcoal filter in the same manner
as the metal grease filter by pressing the filter
latch in to release it. Pull the filter down and out.
800.626.2002
To replace:
1. Insert the black charcoal filter into the opening.
Push the latch on both sides toward the center
and engage the flange.
2. Replace the metal filter—see Metal grease filter
section.
NOTE: Reapply Stainless Steel Magic with the
Monogram polishing cloth after cleaning or if your
unit comes in contact with water, to protect the
fine finish.
Stainless Steel Magic and the Monogram polishing
cloth are available through GE Parts and
Accessories, 800.626.2002 or monogram.com.
For Stainless Steel Magic, order part number
WX10X15.
Do not use appliance wax or polish on any
stainless steel surface.
Do not use scouring pads, powdered cleaners,
bleach or cleaners containing bleach because
these products can scratch and damage
the finish.
Warranty does not cover damage due to
improper cleaning methods.
NOTE: Do not replace with bulbs greater
than 120 volts, 50 watts, or the lights will
automatically shut off and the rings around the
operating buttons will flash to indicate the bulbs
have exceeded the acceptable limits.
Chimney Hood
7