The table below briefly describes how each of the special functions available to the user and to the Service Engineer can be used:
Function
Activation of the function
Buttons
Regeneration
S0
(On/Off)
L2
L3
S2
steady light
(
for 3sec)
Buzzer
Alarm
L2
reading
L3
and
with steady
Components
light
check
[S2]
S0
Cancel
(On/Off)
alarms
L2
L3
with steady
light
Test cycle
Exit / Memorize In order to memorize the functions or exit diagnostics mode, switch the appliance off turning the knob to On/Off position. In most cases the memorization or the exit is
automatic after 60 seconds (in this case the appliance goes to pre-selection mode).
(*)To activate the "user" functions no cycle has to be selected: to cancel them see 5.2.1; the appliance must be in pre-selection mode.