Sequence Of Operation - Electrolux DIVA 45-60-BIG Service Manual

5 SEQUENCE OF OPERATION

1. Switch on the appliance with button S0
the "End of cycle" LED flashes every
2sec for 0.5sec.
eventually, if featured, the Salt/Rinse
aid LEDs light up.
2. Select the delayed start or the desired
option (if featured) pressing button S1.
the LED LD1 lights up.
3. Select the desired programme pressing
sequentially button S2.
the relative LED lights up.
4. If LD2 flashes, there is an alarm condition
press button S2 to try and solve the
problem: if it is not ok LD2 will flash
again; consult the "Alarm" table for the
codification.
5. Close the door
The cycle starts automatically after
3sec or at the end of the countdown (if
the delayed start has been selected)
6. To interrupt a programme in progress:
Open the door carefully.
To restart the cycle, close the door.
NB: Switching the appliance off and on, the
programme restarts from the point at which it
was interrupted.
7. To cancel a programme in progress:
Open the door and press button S2 for
about 3 seconds.
The LEDs LD7 – 8 – 9 light up (if
featured).
The LD1 – 2 LEDs switch off and the
previous settings are cancelled.
8. At the end of the programme:
the buzzer emits a sound sequence.
The LED of the programme, the End of
cycle LED and the Salt/Rinse aid LEDs are
on, if featured.
9. Press button S0 to switch off the
appliance.
All LEDs switch off.
SOI/TD 2005-2 PR
3 sec
8 /26 599 36 83-66