Page 1
2x8 HDMI DA U S E R M A N U A L www.gefen.com...
Page 2
Notice Gefen Inc. reserves the right to make changes in the hard ware, packaging and any accompanying doc u men ta tion without prior written notice. 2x8 HDMI DA is a trademark of Gefen Inc. HDMI is a trademark of hdmi.org...
TABLE OF CONTENTS Introduction Features Panel Descriptions Connecting and Operating the 2x8 HDMI DA RMT2-IR Installation RS-232 Interface Specifi cations Warranty...
HDTV HDMI compatible monitors or projectors. Simply connect your HDTV displays to the DA’s display outputs. The 2x8 HDMI DA can also be placed at the end of a long HDMI cable to regenerate the HDMI signal.
• HDMI or DVI to HDMI cables are used to connect the inputs and switcher output • Inputs can be switched with the IR remote control or through the RS232 connector. • Installs in seconds Includes: (1) 2x8 HDMI DA (1) 6’ HDMI cables (M-M) (1) 24VDC Power Supply (1) RMT2-IR...
CONNECTING AND OPERATING THE 2X8 HDMI DA How to Connect the 2x8 HDMI DA to your devices 1 Connect the supplied cable from the HDTV HDMI source into the 2x8 HDMI DA input. 2 Connect the cables from your displays (monitor or projector) into the HDMI outs of the 2x8 HDMI DA.
RMT2-IR INSTALLATION 1. Remove battery cover from the back of the RMT2-IR remote. 2. Verify that dip switches 1 & 2 are in the down (OFF) position. 3. Insert the battery, hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down.
SPECIFICATIONS Video Amplifi er Bandwidth ................. 1.65 GHz Input Video Signal ..................1.2 volts p-p Input DDC Signal ..................5 volts p-p (TTL) Single Link Range ................1080p / 1920 x 1200 Input Connector Type ....................HDMI Output Connector Type ....................HDMI Remote Control Port ..................
If equipment fails because of such defects and Gefen Inc. is notifi ed within two (2) year from the date of shipment, Gefen Inc. will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical, or other abuse or modifi...