Ssid / Wlan Settings - Cisco 9971 Deployment Manual

Set the WMM Policy to Required
•
Ensure Session Timeout is enabled and configured correctly
•
Ensure Aironet IE is Enabled
•
Set DTPC Support to Enabled
•
Disable P2P (Peer to Peer) Blocking Action / Public Secure Packet Forwarding (PSPF)
•
Ensure Client Exclusion is configured correctly
•
Disable DHCP Address Assignment Required
•
Set MFP Client Protection to Optional or Disabled
•
Set the DTIM Period to 2
•
Set Client Load Balancing to Disabled
•
Set Client Band Select to Disabled
•
Set IGMP Snooping to Enabled
•
Enable Symmetric Mobile Tunneling Mode if Layer 3 mobility is utilized
•
Enable Short Preamble if using 2.4 GHz
•
Enable ClientLink if utilizing Cisco 802.11n Access Points
•
Configure the Data Rates as necessary
•
Enable CCX Location Measurement
•
Configure Auto RF as necessary
•
Set Admission Control Mandatory to Enabled for Voice
•
Set Load Based CAC to Enabled for Voice
•
Enable Traffic Stream Metrics for Voice
•
Set Admission Control Mandatory to Disabled for Video
•
Set EDCA Profile to Voice Optimized or Voice and Video Optimized
•
Set Enable Low Latency MAC to Disabled
•
Ensure that Power Constraint is Disabled
•
Enable Channel Announcement and Channel Quiet Mode
•
Enable CleanAir if utilizing Cisco Access Points with CleanAir technology
•
Configure Multicast Direct Feature as necessary
•
Set the 802.1p tag to 5 for the Platinum QoS profile
•
Note: If clients from other regions are present and will attempt to associate with the wireless LAN, then ensure that World
Mode (802.11d) is enabled.
When using 802.1x authentication, it is recommended to implement CCKM to offer fast secure roaming.

SSID / WLAN Settings

It is recommended to have a separate SSID for the Cisco Unified IP Phone 9971.
However, if there is an existing SSID configured to support voice capable Cisco Wireless LAN endpoints already, then that
WLAN can be utilized instead.
Cisco Unified IP Phone 9971 Wireless LAN Deployment Guide
57