Cisco 9971 Deployment Manual page 48

Display Idle Timeout
HTTPS Server
Enable Power Save Plus
Phone On Time
Phone Off Time
Phone Off Idle Timeout
Cisco Unified IP Phone 9971 Wireless LAN Deployment Guide
hours. This value is in free form hours and minutes. "1:30" would activate the
display for one hour and 30 minutes.
This field indicates how long to wait before the display is turned off when it was
turned on by user activity. This inactivity timer will continually reset itself during
user activity. Leaving this field blank will make the phone use a pre-determined
default value of one hour. Maximum value is 24 hours. This value can be in free
form hours and minutes. "1:30" would turn off the display after one hour and 30
minutes of inactivity
Allows Administrator to permit http and https or https only connections if Web
Access is enabled.
To enable the Power Save Plus feature, select the day(s) that you want the phone
to power off on schedule. You can select multiple days by pressing and holding
the Control key while clicking on the days that you want Power Save Plus to
operate. The default is disabled (no days selected). In Power Save Plus mode,
enough power is maintained to illuminate one key. All other functions of the
phone are turned off in Power Save Plus mode. Power Save Plus mode turns off
the phone for the time period specified in the Phone On Time and Phone Off
Time fields. This time period is usually outside of your organization's regular
operating hours. The illuminated key allows a user to press it to restore full power
to the phone. After pressing the illuminated key, the phone power-cycles and
reregisters with Unified CM before it becomes fully operational. Power Save Plus
is disabled by default. When you select day(s) in this field, the following notice
displays to indicate e911 concerns. By enabling Power Save Plus, you are
agreeing to the terms specified in this Notice.
While Power Save Plus Mode (The "Mode") is in effect, endpoints configured for
the mode are disabled for emergency calling and from receiving inbound calls.
By selecting this mode, you agree to the following: (I) You are taking full
responsibility for providing alternate methods for emergency calling and
receiving calls while the mode is in effect; (II) Cisco has no liability in
connection with your selection of the mode and all liability in connection with
enabling the mode is your responsibility; and (III) You will fully inform users of
the effects of the mode on calls, calling and otherwise.
This field determines the time that the phone turns on automatically on the days
that are selected in the Enable Power Save Plus list box. Enter the time in 24 hour
format, where 00:00 represents midnight. For example, to automatically turn the
phone on at 7:00 a.m., (0700), enter 07:00. To turn the phone on at 2:00 p.m.
(1400), enter 14:00. If this field is blank, the phone automatically turns on at
00:00.
This field determines the time of day that the phone will turn itself off on the days
that are selected in the Enable Power Save Plus list box. Enter the time in the
following format hours:minutes. If this field is blank, the phone automatically
turns off at midnight (00:00). Note: If Phone On Time is blank (or 00:00) and
Phone Off Time is blank (or 24:00), the phone will remain on continuously,
effectively disabling the Power Save Plus feature unless you allow EnergyWise
to send overrides.
This field represents the number of minutes that the device must be idle before
the device will request the power sourcing equipment (PSE) to power down the
device. The value in this field takes effect: - When the device was in Power Save
Plus mode as scheduled and was taken out of Power Save Plus mode because the
phone user pressed the select key - When the phone is repowered by the attached
switch - When the Phone Off Time is met but the phone is in use. The unit is
48